Category: Tablets Repair and Service
Contents of this article
- How to remove the case
- How to remove the battery
- How to remove the mother board
Orbo Jr. Tablet
Use your thumbs to gently pry the silicon case away from the tablet starting at one of the corners. Once the first corner is separated the other three corners should slip off easily.
Use the plastic opening tool to pry the back off the tablet. Work your way around the edges. Once you have one side open you can slowly unsnap the rest of the case and use the tool as needed.
Go slowly when you pry the back off to ensure you do not crack the case or damage the screen.
Gently pull the cables attached to the speaker to remove it from the back cover.
The speaker is taped in the back cover and caution should be used when pulling on the wires.
Pull back the tape to expose the wires that are attached to the battery.
Do not attempt to fully remove the battery. It is still connected to the motherboard by two wires.
Use a nylon spudger to lift the battery from the right side of the device. Slowly remove the adhesive below the battery.
To avoid damage to device and battery, do not attempt to remove the battery until adhesive is completely detached.
To avoid damage to device and battery, do not attempt to remove the battery until adhesive is completely detached.
Desolder the battery wires from the positive and negative connection to the motherboard
Be careful to not make contact to other components on the motherboard while using the soldering iron
Unsolder the positive and negative speaker wires from the connection on the motherboard.
Positive and Negative battery terminals.
Be careful to not make contact to other components on the motherboard while using the solder iron.
Be careful to not make contact to other components on the motherboard while using the solder iron.
Use the pointed end of a spudger to flip up the black tab connecting the camera's ribbon cable to the motherboard.
Pull lightly on the ribbon to remove the camera ribbon from the tab.
Pull lightly on the ribbon to remove the camera ribbon from the tab.
Unsolder the Wifi wire from the connection on the motherboard.
Be careful to not make contact to other components on the motherboard while using the solder iron.
Unsolder the display wires from the connection on the motherboard.
Be careful to not make contact to other components on the motherboard while using the solder iron.
Use the flat end of the spudger to lift and remove the black tape covering the ribbon connection tab.
The tape should be removed slowly.
Using the tip end of the spudger, slide back the black clips on the side of the right ribbon connection.
Gently pull the display ribbons to remove them from the motherboard connections.
Repeat the same steps for the left ribbon connection.
Repeat the same steps for the left ribbon connection.
Remove the following Phillips #000 screws securing the motherboard and remove it.
Không có nhận xét nào:
Đăng nhận xét