Lift the rubber flap covering the input/output jacks.
Using a Phillips #0, remove the single 3.4 mm screw.
This step will permanently erase all user settings.
The memory battery can now be easily slid out of place.
Peel back the rubber cover above the in/out ports to reveal two screwheads.
Remove both 5.4 mm screws using a Phillips #0.
Lift the in/out port plastic covering from the bottom where the backupbattery used to be.
Remove each 6.3 mm screw on either side of the viewfinder using a Phillips #0 screwdriver.
Remove the three 4.8 mm screws on the bottom of the back plate using a Phillips #0.
Peel back the rubber covering next to the menu dial to access thescrew.
Remove the single 3.4 mm screw using a Phillips #0.
The back panel can now fall off easily by turning the device upside down. Be sure to catch it so the data ribbons do not tear or tug.
Remove each data ribbon cable from the motherboard by applyingpressure down towards the motherboard and gently sliding your thumb upwards on the slot where the cable meets the motherboard. Thiswill raise a very small clip that locks the cable in place.
The back panel is now free from the rest of the device.
Remove each of the 3.4 mm screws holding in the LCD using a Phillips #0.
Grip the wire attaching the speaker to the data ribbon cable and pull itout.
The LCD is now free from the back panel.
Không có nhận xét nào:
Đăng nhận xét